41
Port1 Link Change to DOWN
set the duplex mode ok!
Switch(config-if)# Port1 Link Change to UP
Port Control – Flow Control
Switch(config-if)# flowcontrol on
Flowcontrol on for port 1 set ok!
Switch(config-if)# flowcontrol off
Flowcontrol off for port 1 set ok!
Port Status
Port Status
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Connected
Duplex : Full
Speed : 100
Flow Control :off
Default Port VLAN ID: 1
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Mdix mode is Disable.
Medium mode is Copper.
Note: Administrative Status -> Port state of the port.
Operating status -> Current status of the port. Duplex ->
Duplex mode of the port. Speed -> Speed mode of the port.
Flow control -> Flow Control status of the port.
Rate Control
Rate Control – Ingress or Egress Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or
Egress rule first; then assign the packet type and bandwidth.
