Kopp INFRAcontrol R 240, Operating Instructions Manual

Page: 69 / 112

69
Safety Instructions
Installation only by persons with the relevant electrical
and technical knowledge and experience.
Through improper installation, you endanger:
• Your own life
• The life of the user of the electrical system
Through improper installation, you risk serious property
damage, e.g. by fire.
You shall be at risk of personal liability for personal injury
and property damage.
Contact an electrical installer!
For the installation, the following specialist knowledge in
particular is required:
• The applicable “5 safety rules”: Disconnect; secure
against switching on again; check that there is no
voltage; earth and short-circuit; cover or block off
adjacent parts still under voltage
• Select a suitable tool, measuring devices and, if
necessary, personal protective equipment
• Evaluate the measurement results
• Select the electrical installation material to
ensure disconnected state
• IP protection types
• Installation of the electrical installation material
• Type of supply network (TN system, IT system,
TT system) and the resulting connection requirements
(classic zero, protective grounding, additional measures
required, etc.…)
• Do not install on a conductive surface
Please note the attached connection diagrams when con-
necting. Damaged or partially damaged devices must not
be connected and cannot be used.
Make sure before installing that the conductors to be con-
nected and already connected to the device are not under
voltage.
Make sure that the cabinet in which the device is to be
installed excludes accidental contact with the terminals
after the installation cover has been installed.
Observe the rules of electrical engineering and DIN VDE
0100.
GB