KONTRON
speedMOPSlcdCE User’s Guide
21
Graphic Interfaces
8.
GRAPHICS INTERFACES
8.1
Video Controller
The speedMOPSlcdCE uses the graphics accelerator integrated in the Intel® 815E chipset. It
delivers high performance 2D, 3D and video capabilities. With its interface to UMA (Unified Memory
Architecture), up to 1MB of legacy system memory is used as video memory. The video memory can
be extended to 32MB by the use of the available “Intel® Extreme Graphics” drivers.
The controller can drive two interfaces with its graphics engines on the speedMOPSlcdCE:
Cathode Ray Tube (CRT) interface
Low Voltage Differential Signaling (LVDS) interface
8.2
CRT Connector
The CRT monitor interface is available through the J2 connector (6 pins). To find the location of the
connectors see the Appendix E: Connector Layout chapter. To have the signals available on a
standard DSUB-15 CRT monitor connector, an adapter cable is required. A 15-pin DSUB cable is
available from Kontron (KAB-VGA-2, Part Number 96053-0000-00-0).
The following table shows the pin-out of the CRT connector.
Header
Pin
Signal Name
Function
DSUB-25
1
RED
Analog video red
1
2
GRN
Analog video green
2
3
BLU
Analog video blue
3
4
GND
Signal ground
7
5
VSYNC
Vertical sync
14
6
HSYNC
Horizontal sync
13
Summary of Contents for speedMOPSlcdCE
