mITX-SKL-H – User Guide, Rev.1.1
www.kontron.com
// 20
4.5.
Supported Processors
The mITX-SKL-H supports a factory mounted BGA CPU (BGA1440) Intel® Xeon®, Core™ i7, Core™ i5, or Celeron®
processor. All board versions are based on embedded CPUs.
Intel® Xeon® E3 1505M 45W GT2, CM236 WS PCH, VPro™, non-ECC/ECC
Intel® Core™ i7 6820EQ 45W GT2, CM236 WS PCH, non-ECC
Intel® Core™ i5-6440 EQ 45W GT2, CM236 WS PCH, non –ECC
Intel® Celeron® G3900E 35W GT1, CM236 WS PCH, non-ECC/ECC
4.5.1.
Processor Cooling
Sufficient cooling must be applied to the processor in order to remove the effects of TDP (Thermal Design Power).
The level of sufficient cooling also depends on the worst-case maximum ambient operating temperature and the
actual worst-case load of processor.
mITX-SKL-H is delivered with pre-installed cooler
,
the Kontron PN 1060-1672 “CPU Cooler mITX-SKL-H”:
Figure 2: CPU Cooler mITX-SKL-H, height above PCB = 44.7 mm
4.6.
System Memory
The mITX-SKL-H supports a dual channel DDR4 memory interface with one SO-DIMM socket per channel. The sockets
support the following memory features:
2x DDR4 260-pin SO-DIMM 260 (ECC and non-ECC)
ECC supported for Xeon and Celeron SKU only
2x SO-DIMM sockets, one per channel
Maximum supported memory 32 GB
Memory controller supports speeds of 1866/2133 MHz
If using 32-bit OS, less than 4GB is displayed in system.
(Shared Video Memory/PCI resources are subtracted).
The installed DDR4 SO-DIMM should support the Serial Presence Detect (SPD) data structure. This allows the BIOS to
read and configure the memory controller for optimal performance. If non-SPD memory is used, the BIOS will attempt
to configure the memory settings, but performance and reliability may be impacted, or the board may not be able to
boot totally.
Fan Adda Ad5012UB-C7B
Up to 7000 RPM
Alu fin
Backplate
Copper Plate
