Configuration
CP6003-SA
Page 4 - 4
ID 1044-9757, Rev. 2.0
P R E L I M I N A R Y
To clear the uEFI BIOS settings, proceed as follows:
1. Set the DIP Switch SW1, switch 4, to the ON position.
2. Apply power to the system.
3. After 30 seconds, remove power from the system.
During this time period of approx. 30 seconds, no messages are displayed.
4. Set the DIP Switch SW1, switch 4 to the OFF position.
4.1.2
DIP Switches SW2 and SW3 Configuration
Figure 4-2: DIP Switches SW2 and SW3
The default settings of the DIP switches are indicated by using italic bold.
Table 4-2:
DIP Switch SW2 for CompactPCI Interface Configuration
SWITCH 1
SETTING
DESCRIPTION
1
OFF
PCI 33 MHz / 66 MHz auto detection via the CompactPCI backplane
ON
PCI frequency configured to 33 MHz
2
OFF
PCI / PCI-X mode auto detection via the CompactPCI backplane
ON
CP6003-SA configured to PCI mode
Table 4-3:
DIP Switch SW3 for PMC Interface Configuration
SWITCH 1
SETTING
DESCRIPTION
1
OFF
PCI / PCI-X frequency multiplier configured to 33 MHz
ON
PCI / PCI-X frequency multiplier configured to 25 MHz
2
OFF
PCI / PCI-X mode auto detection via the PMC module
ON
PMC interface configured to PCI mode
