CP6000
Configuration
ID 27942, Rev. 05
© 2005 Kontron Modular Computers GmbH
Page 4 - 3
2794
2.05.UG.VC.051020/17275
8
P R E L I M I N A R Y
4.
Configuration
4.1
Jumper Description
4.1.1
CompactFlash Configuration
The default setting is indicated by using italic bold.
4.1.2
Clearing BIOS CMOS Setup
If the system does not boot (due to, for example, the wrong BIOS configuration, or wrong pass-
word setting), the CMOS setting may be cleared using jumper J15.
Procedure for clearing CMOS setting:
The system is booted with the jumper in the new, closed position, then powered down again.
The jumper is reset back to the normal position, then the system is rebooted again
The default setting is indicated by using italic bold.
4.1.3
Shorting Chassis GND (Shield) to Logic GND
The front panel and front panel connectors are isolated to the logic ground.
To enable the connection between the chassis GND and logic GND the capacitors must be
exchanged with zero ohm resistors.
The default setting is indicated by using italic bold.
Table 4-1: CompactFlash Configuration
R347 / J16
DESCRIPTION
Open
Configured for master
Closed
Configured for slave
Table 4-2: Clearing BIOS CMOS Setup
J15
DESCRIPTION
Open
Normal boot using the CMOS settings
Closed
Clear the CMOS settings and use the default values
Table 4-3: Shorting Chassis GND (Shield) to Logic GND
CAPACITOR
SETTING
DESCRIPTION
C51, C66, C78
Closed 470pF 2KV capacitors
Connectors are isolated to logic GND with three
470pF 2KV capacitors
Closed zero ohm resistors
Connectors are connected to logic GND and chassis
GND
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
