koenner-soehnen.com
|
16
Use only the recommended oils and fuels for repairs and maintenance. The use of other lubricants,
consumables and spare parts deprives you of the right to warranty service. Power plant maintenance
should only be carried out by qualified personnel. To find out where the nearest service center is located,
please contact the point of sale, or look for an up-to-date list of service centers on the importer official
website:
www.koenner-soehnen.com
ENGINE OIL REPLACEMENT OR ADDING
ENGINE OIL REPLACEMENT OR ADDING
Upon oil level decrease it is necessary to add the required quantity in order to provide the correct generator
operation. It is necessary to check the oil levels according to technical maintenance schedule. When
changing the oil, remove the oil filter, flush it with gasoline and install it back.
TO DRAIN THE OIL:
TO DRAIN THE OIL:
Open the oil filler cap at the top of the engine (fig. 4, item 13). Open the oil drain tap (fig. 4, item 6), which
is located at the bottom of the crankcase, wait for the oil to drain completely, close the tap and fill in new
oil. To drain as much oil as possible, perform the procedure on a preheated engine.
OIL FILLING:
OIL FILLING:
1.
Make sure that the generator is set on flat level surface.
2. Unscrew the oil gage cap on the engine
(fig. 4, p. 5).
3.
By means of a funnel, pour the advanced purification engine oil to the crankcase (fig. 4, p.13).
Oil level
after filling has to be close to the upper part of oil filler.
4. Check the oil level with a dipstick.
AIR FILTER MAINTENANCE
11
It is necessary to check the air
filter from time to time and clean
any contaminations. Regular air
filter maintenance is necessary
to maintain sufficient carburetor
air inflow. The air filter should be
cleaned more often when using
generator in dusty conditions.
Never run the engine with the air filter removed or
without the filter. Otherwise dirt and dust lead to rapid
breakage of engine parts. Failure in this case will not be
repaired.
ATTENTION - DANGER!
Air filter replacement is to be performed each 250 hours
of the generator operation (every 100 hours in unusual-
ly dusty conditions).
IMPORTANT!
FUEL FILTER TECHNICAL MAINTENANCE
12
COARSE CLEANING FUEL FILTER (IF INSTALLED)
COARSE CLEANING FUEL FILTER (IF INSTALLED)
Remove the filter after the possible hard particles hit every 200 operating hours. Never use water for
purification the filter.
1. Remove the fuel cap.
2. Remove the fuel filter.
3. Use diesel fuel to clean the filter.
4. Put the filter back to the fuel tank.
There are two kinds of fuel filters in
Könner & Söhnen
®
diesel generators. They prevent the ingress of
contaminants from diesel fuel to the engine.
Summary of Contents for KS 18-1DE-G
Page 22: ......
