KONLEN TECHNOLOGY LIMITED
Website: www.konlen.com
U1 building, Oriental Garden, NanShan District, Shenzhen City, Guangdong Province,China
Tel: +86-(0)755-86082432 E-mail:
MSN:
Skype: securitykonlen
6
3.
In the above SMS operation, you will receive a reply message for confirmation after sending message command to
the host. Such as:
DisArm, Sms:ON, Phone:ON, Siren:ON, Center Tel:OFF, Arm Center Tel:OFF, DisArm Center Tel:OFF
If the replied message is about the current status of the host, you may have sent wrong command.
4. You can also send inquiry command to check out the present status of the host.
5. When the external power is cut off, the system will send SMS “Power changer off” to inform. When the external
power resumed, the system will send SMS “Power changer on” to inform.
How to use remote controllers
There are four buttons on the remote controller:
Out Arm key. Press this button, the signal LED flash slowly in orange for 10 seconds, system is in arm wait status. 10
seconds later, the signal LED flash slowly in green, system is in out arm status now. You can set out arm mode when no
one is at home, all the detectors at home will be in working mode.
Home Arm key. Press this button, the signal LED flash slowly in orange for 10 seconds, system is in arm wait status.
10 seconds later, the signal LED will flash quickly in green, system is in home arm status now. You can set home arm
mode when there is some one at home, sensors in inner defense zone will be invalid, but sensors in other defense zones
still work normally.
Disarm key. Press this button, all the detectors are disarmed, the light on panel will keep on in green.
Alarm key. Press this button, the light on panel will flash in red; the system will be alarming, and the host will send the
SMS and dial out.
How to add more detectors
You can add more sensors and detectors, such as wireless door sensors, PIR sensors, gas and smoke detectors into the
host.
1) Add sensors ready to work when you set both Out Arm and Home Arm:
When the GSM host begins to be powered on, the status LED light on panel will be red for 20 seconds, this is code
learning mode. You can trigger the sensors or detectors, and the red LED will flash to show it is coded successfully into
the host.