KONLEN TECHNOLOGY LIMITED
Website: www.konlen.com
U1 building, Oriental Garden, NanShan District, Shenzhen City, Guangdong Province,China
Tel: +86-(0)755-86082432 E-mail:
MSN:
Skype: securitykonlen
1
Brief Introduction:
◆
GSM 900/1800/1900 bands, can be used in most parts of the world
◆
Full duplex communication with the host
◆
Monitor the scene environment
◆
Voice and message alert
◆
Set alarm ON or OFF by remote controller
◆
Can set Home Arm and Out Arm mode
◆
Call in to set alarm ON, OFF, Monitor, Output, Intercom.
◆
Send SMS to set alarm ON, OFF, Monitor, Output
◆
5 group phone + room 1 group alarm monitor center phone number
◆
2 group phone to report arm and disarm status
◆
Can program 7 groups of alarm messages
◆
3 zones for wired detector
◆
16 zones for wireless detector
◆
2 outputs, can be used with external circuit to control home appliance
◆
Easily set ON or OFF for every wired or wireless detector
◆
SMS inform if external power failure or recovery
Basic Kit contains:
-
Alarm system ( alarm host ) – 1 pc.
-
Wireless PIR detector – 1 pc.
-
Wireless door (gap) sensor – 1 pc.
-
Remote controller – 2 pcs.
-
Antenna – 1pc.
-
Mini wired siren 110dB/0.3m – 1 pc.
-
Power supply with back-up – 1pc.
-
Installation/user manual – 1pc.
Installation guide:
1. Insert SIM in alarm unit.
Press the yellow point on top of the main unit with a pencil tip or other tools, SIM tray will come out. Put the SIM
card carefully into the tray, and make sure the metal contacts of the SIM to be down.
Note: Before inserting SIM card into alarm unit, using a regular mobile phone to do the following steps:
-
Set PIN code request to off.
-
Delete all stored numbers.
2. Connect the antenna.
Screw the antenna to the connection on top of the main unit. Take care not to over-tight the nut or let it loose!
3. Insert the power supply.
Connect the host with the adaptor. The host need 9V-12V DC, must be over 1000mA current.
The signal status LED on the main unit panel will turn to red and last for 20 seconds, this is code learning
mode, system is waiting for wireless detectors to be coded into the host;
After 20 seconds, the signal status LED will turn to orange, and begin to flash, indicating system is checking
SIM card and search for GSM network;
After main unit finish checking the host, if the signal status LED turns to green and flashes slowly, it shows
alarm phone number have been saved in the host, and the host is in arm status. If the signal status LED keeps
on in green, it shows phone numbers have not been saved in the host, and the host is in disarm status. You can