KONLEN TECHNOLOGY LIMITED
Website: www.konlen.com
U1 building, Oriental Garden, NanShan District, Shenzhen City, Guangdong Province,China
Tel: +86-(0)755-86082432 E-mail:
MSN:
Skype: securitykonlen
4
123456#82#Middle door open#: save second group message into the host as second wireless detector is triggered.
123456#83#Back door open#: save third group message into the host as third wireless detector is triggered.
123456#84#Front window open#: save fourth group message into the host as fourth wireless detector is triggered.
123456#85#Back window open#: save fifth group message into the host as fifth wireless detector is triggered.
123456#86#Middle window open#: save sixth group message into the host as sixth- sixteenth wireless detector is
triggered.
123456#87#Kitchen opened#: save seventh group message into the host as port 1 to 3 wired detector is triggered.
How to operate when the host is alarming
In normal usage, if the host is in disarm status, the signal LED keeps on in green. You can use remote controller to
change the host into arm status, or you may send command (123456#1#1#) to the host to change the host into arm
status, the signal LED will flash in green in arm status.
1.
Under arm status, any port of input (I1, I2, I3) touches ground or let it open, or wireless detectors activated, or
press of alarm key of the controller, the alarm system will send alarm information by SMS, and dial out stored
telephone numbers.
2.
The system will send preset alarm message before dialing alarm phone numbers. If the SMS has been closed
or limited, it will only dial out the alarm telephone numbers.
3.
When there is alarm, you can answer the phone (no need to input password) for listen-in, remote control.
Press 3#1# to sound the siren and press 3#0# to stop it, press 4#1# to start to listen-in and press 4#0# to stop it,
press 93#1# to start to talk to the host and press 93#0# to stop it.
4.
After picking up alarming calls, if you do not need the host dial next phone number programmed in the host,
just press 1#1# or 1#2# to re-turn the host to arm status.
5.
When there is alarm, users can also use the controller to disarm the host if they are near by.
6.
In normal usage, with inside recharge battery on, you will receive the message “external power failure” or
“external power recovery” when external power supply lost or recovered.