KONIG+NEURATH TALO.S, Assembly Instructions Manual

Page: 28 / 38

25
(a)
(b)
(c)
10.
Fitting the CPU
holder
Attach the CPU - holder (a)
to the retaining plate (b) with
counter - sunk screws M5x16
(SW3).
Fit the square shaft and con -
necting clamp as described
in Figure 9.
Attach the CPU holder re -
taining plate to the connec -
ting clamp (as in Fig.9).
It can optionally be fitted
facing outwards or inwards.
Desks with fold - out cable
tray: only outwards!
The printer tray can be
fitted at the same time if the
retaining plates (c) are offset
from each other.
Please see note under figu
-
re 9!
(c)
(e)
(d)
(a)
(b)
11.
Fitting the mo -
desty panel
Remove the end cap (a)
from the frame console.
Place the threaded plate (b)
into the console.
Screw the modesty panel
bracket (c) to the plate inside
from underneath through the
console, use cylinder head
screws M6x16 (SW5).
Fit the modesty panel (d) on -
to the modesty panel bracket
using pan - head screws M6x8
(SW4).
Replace the end cap (e) in
the console.