E-19
VII. Importing Adjustment Data
Import the factory adjustment data of the PB-501 to
the machine memory.
If a PB-501 and other optional units are connected,
they can recover the standard data at the same
time.
Note:
Be sure to import the factory adjustment data of
the PB-501 to the machine memory.
VIII. Installation Confirmation
Conduct an operating check to determine that the
folding unit full detection is working.
Note:
Only confirm if the machine combination is included
PB-501 and FD-501 (FD-503).
*Confirmation method
1. Press the switch on the PB (A in the figure) to see
if the switch on the FD (B in the figure) turns ON.
2. Turn the main unit's power ON, and press the
switch on the PB (A in the figure) to see if the
message “Perfect Binder Sub Tray is full Please
remove paper.” appears on the control panel.
*Adjustment method
If the FD full detection does not turn ON, adjust the
casters of the PB-501 main unit and raise it to acti-
vate the FD full detection.
IX. Confirmation of Paper Output
Output paper. If bind results are not good, adjust the
settings.
See the Service Manual for adjustment method.
X. Adjustment Data Backup
If the PB-501 adjustment data is changed, back up
the machine PB-501 data to the PB-501 memory.
If a PB-501 and other optional units are connected,
the data will be backed up to both memories at the
same time.
Step
1. Plug the power cord into the outlet and turn
ON the Main power switch.
2. Enter Service mode.
Note:
Refer to procedures in the Service Manual to
enter into the Service Mode.
3. Touch “Finisher Adjustment”.
4. [Finisher Adjustment Menu screen]
Touch “Recall Standard Data”.
5. Touch “Factory Initial Data” on the recall stan-
dard data screen.
A075IXC015SA
A
B
Step
1. On the Service mode menu screen, touch
“Machine Condition (1050 series)” or “State
Confirmation (C6500/C6501 series)”.
2. Touch “I/O Check Mode”.
3. Enter “9” and “0” using the quantity setting but-
tons. Make sure that <1050 series 090-00/
C6500/C6501 series 90-00> appears on the
message display.
4. Press the [Start] key.
Backup procedure will start.
