Konica Minolta bizhub proc6500, User Manual

Page: 58 / 414

Adjustment
3
bizhub PRO C6500 3-25
4
Load the desired size of paper to be adjusted on a tray, touch Staple
and then press [Start].
A sample pattern (No. 16) will be output.
5
Open the Finisher door, and with-
draw the Staple unit.
– Confirm the distance between
the fixed plates and output pa-
per.
– When selecting the paper which
length side is 239mm or longer,
the Staple unit can not be
withdrawn.
– Remove output paper from the paper exit side, withdraw the staple
unit, and then reset the output paper in the unit.
6
Check misalignment (a), in which misalignment occurs if the paper
width setting is larger than the actual width, or paper curving (b), in
which a sample set is curved if the paper width setting is smaller than
the actual width has occurred.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Paper Width (Staple) Screen will be restored.
a
b
bizhub_C6500.book Page 25 Monday, September 11, 2006 1:36 PM