Konica Minolta bizhub proc6500, User Manual

Page: 118 / 414

Adjustment
3
bizhub PRO C6500 3-85
5
Load the paper on the desired tray (main body tray or Paper inserter
tray) to be adjusted, specify Punch, then press [Start] on the control
panel.
A sample pattern (No. 16) will be output.
6
Check the distance (a) from the edge of the output sheet to the center
of the punch hole.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Horizontal Position Adjustment Screen will be restored.
8
Touch [+ 5 -] to specify the value to be positive or negative. Use the
touch panel keypad to enter the desired adjustment value, then touch
[<<SET].
Available range: -50 (wide) to +50 (narrow), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is
obtained.
10
If adjustment in any other tray is required, repeat steps from 3 to 9.
11
Touch [Return] to restore the Adjustment Menu Screen.
a
[2]
[1]
bizhub_C6500.book Page 85 Monday, September 11, 2006 1:36 PM