E-25
(6) Mount the supplied stamp in stamp unit.
Note:
Align the round pin of the stamp with the slit in the
stamp unit side.
(7) Install the stamp unit and the ground terminal.
(One screw removed in step (5))
Note:
Tighten the unit together with the ground terminal.
Ground terminal
Stamp unit
(8) Connect the stamp unit connector to the main
body relay connector.
(9) Place the relay connector at the location shown
in the illustration and pass the stamp unit har-
ness through the gap of the rib.
Note:
Make sure that the wire harness does not inter-
fere with the roller.
Connector
Rib
(10) Reinstall the stamp unit cover.
(11) Close the original tray.
(12) Pinch the slot portion at the underside of the
lock lever and pull it out.
Slot
(13) Close the top door.
3. Configuration procedures
(1) Plug the power cord into the power outlet and
turn ON the main power switch.
(2) Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
(3) Touch “System 2.”
(4) Touch “Stamp.”
(5) Touch “Set.”
(6) Touch “END.”
(7) Touch “Exit” on the Service Mode screen.
(8) Turn OFF and ON the main power switch.
Note:
When displayed the Service Mode screen, be
sure to turn off the power after exiting the Service
Mode screen and wait for 10 seconds or more be-
fore turning on.
