Simrad AP20 Autopilot
82
20220505H
on and if an attempt is made to access the AUTO or NAV
modes prior to completion of setup.
•
The Dockside, Interface and Seatrial settings can only be
accessed when the system is in STBY mode.
•
The values that are selected (also referred to as
"PARAMETERS") from within the Installation Settings
Menu, are stored in the memory of the AP20 system. No
specific action is required to "SAVE" the selected values.
Once the value is changed, it is stored until the next time the
menu item is selected and changed.
•
The Installation Settings are considered global, enabling
values to be available to all control units in the system.
•
The values in the Seatrial Settings are dependent on
successful completion of the Dockside Settings.
Before attempting to turn on the AP20 and perform an
Installation Setup, the hardware installation and electrical
installation must be completed in accordance with the
installation instructions.
Installation Menu
The Installation Menu (IM) is presented on the autopilot display
by pressing and holding the NAV/SETUP push-button for 5
seconds.
Language
Dockside
Interface
Seatrial
Parameters
NMEA Test
Display Units
Master Reset
SW V1R3
May 14 2002
09:38 0 00
No
Yes
Note !
The INSTALLATION MENU is different from the USER SETUP
MENU . Refer to flow diagram on the next page for a pictorial
view of the Installation Menu.