Operation
20220505H
15
After approx. 5 seconds the system is operative and the unit that
was turned on will show the STBY mode display. Other units in
a multistation system will display "Inactive". Control can be
available at any unit by pressing the STBY button.
A long press (2-3 sec.) on the STBY button switches the system
OFF.
Note !
In an emergency it is possible on a multistation system to turn
OFF the system at any control unit by pressing down the STBY
button for 2-3 seconds.
STBY mode is also the mode
that is used when steering the
boat at the helm.
Display information:
Standby mode, current heading
345° and rudder angle 2° to
starboard.
Flashing course knob icon
When the course knob is used for settings etc., an
icon will flash on the screen to tell that no course
changes can be made unless you press the AUTO
button.
2.3
AP20 with MSD50 Stern Drive unit
Note !
The information in section 2.3 only applies if your autopilot is
driving a Simrad MSD50 Stern Drive.
The MSD50 Stern drive unit has a relative feedback signal which
needs a zero point setting after the autopilot has been turned on.
Refer to page 1-1 of the MSD50 manual for further information.
Zero point setting
Note !
If you do not need a rudder angle display when leaving the dock,
just steer the boat manually on a straight course and press the
AUTO button. The zero point is then set auto-matically.
02
P S
RUDDER