Operation
20220505H
33
Pos Source GPS1
Select Compass
RFC
Course adjust 1°
System data
NMEA data
SETUP
Select the compass to be used for AUTO steering, if more than
one compass is connected. Refer to the interface setup table on
page 93.
RFC = Simrad RFC35 Fluxgate compass or Simrad
RFC35R Rate compass (See Note)
MAGN
=
Magnetic compass (or Simrad RFC35 Fluxgate
Compass.
(See
Note)
FLUXG = Non-Simrad fluxgate compass
GYRO = Simrad gyrocompass
NMEA = NMEA compass (Applies for AP20 V1R3/
J300X V1R8 onwards)
Note !
It is necessary to select the correct compass and Nav. source to
make the autopilot operate. If a Simrad RFC35 Fluxgate
compass is used as backup to the RFC35R, it is selected when
MAGN is displayed.
Pos Source GPS1
Select Compass
RFC
Course adjust 1°
System data
NMEA data
SETUP
When using the PORT or STBD buttons in automatic mode you
are changing the set course in 1° increments. If you prefer the
increments to be 10° each press, proceed as per below:
Select
Course adjust
using the PORT or STBD button. Turn the
rotary knob to display the setting. The default value is 1° which
is the preferred setting. Select 10° if you want to make major
course changes in 10° steps with the buttons and fine tune the set
course with the rotary knob.
Note !
The course adjust menu item is available from software version
V1R2 onwards.