11
2-1 PCB start-up check (self test)
•For networking, be sure to connect with the same “RACING JAM
TM
CHAPTER II” machine.
•Be sure to check the PCB (self test) before using the machine.
•Before use, be sure to adjust the on-screen display of the projector (refer
to page 15).
•If an abnormality persists or the machine does not operate properly,
immediately turn OFF the power switch, unplug the power cord from the
receptacle and contact your nearest dealer.
2 PCB settings
Result of test
· The steering wheel and other components are automatically repositioned. The
machine then goes to the game mode and the demonstration game gets started.
If test is OK
When the power switch is turned ON after replacement of the PCB unit, the
performance of game Printed Circuit Boards (PCB) is checked automatically and the
result is displayed on the screen.
· “ BAD ” or “HARDWARE ERROR(***)”appears on the screen, and the checking
is repeated.
If “OPTION SETTINGS BACKUP DATA ERROR.” and “PRESS TEST SWITCH
TO ALL FACTORY SETTINGS.” appear, press the test switch on the service
panel. (The settings made in the manual test will be back to the factory
settings.)
If “RECORD BACKUP DATA ERROR.” and “PRESS TEST SWITCH TO
RECORD DATA CLEAR.” appear, press the test switch on the service panel.
(The course record will be back to the factory setting.)
If “BOOKKEEPING BACKUP DATA ERROR.” and “PRESS TEST SWITCH TO
DATA INITIALIZE.” appear, press the test switch on the service panel. (The
bookkeeping data will be back to the factory setting.)
If an abnormal display continues or the machine does not operate normally,
immediately turn OFF the power switch and contact your nearest dealer.
If any abnormality is detected
