Komatsu Utility PC26MR-3, Operation & Maintenance Manual

Page: 96 / 252

INSTRUMENTS AND CONTROLS
94 WEAM009500
9. Open the inspection door (7), pull the cab floor release lever
(8) in the direction indicated by the arrow (backwards) with
your left hand and at the same time push the handle (9) up-
ward in the direction indicated by the arrow (approx. 45°).
The canopy or cab are an integral part of the machine, as
well as the cab floor, and they are all lifted together.
IMPORTANT
q
If the cab floor cannot be lifted, this means that the release
lever (8) isn't in the correct release position.
Pull the handle (9) backwards with your right hand, then re-
peat the procedure described above.
q
When tilting or closing the cab floor, be extremely careful,
and keep away from the area under the cab floor.
NOTE
q
The cab floor tilts thanks to the operation of a gas cylinder, so
when the ambient temperature is low, the operating effort in-
creases.
10. After tilting the floor open, make sure that the locking pin (10)
is inserted in the groove (12) of the locking plate (11).
11. Insert the safety pin (13) in the hole (14) from the inside.
12. Turn until the coupling at the end of the safety pin (13) is
completely engaged with the pin (15).
NOTE
q
Make sure that the safety pin (13) is correctly engaged with the
pin (15).