Kolver 035001, Manual

Page: 14 / 64

Vers. 291020
14
9- RUN TIME: set the time of a tightening, from 0,1 to 19,90 sec.
The couple reached during this time results in a signal of
Correct screw . If the correct screw
signal is not required, set the Minimum time up to a value of Run Time -0.1sec'.
10- RAMP: select the slow start time (acceleration) from 0,3 to 3,0 sec. If you wish to see an
error signal during the preset torque in the ramp phase, you can change the minimum time
by setting value which is equal or superior to the ramp value (see #8).
MENU REV & PRE-REV:
1- Program number.
2- Values of Reverse speed, Reverse torque, Pre-tightening reverse, Pre-rev delay, Auto-
reverse after torque and auto-rev delay functions.
3- Flags referring to PRE-TIGHTENING REVERSE function.
It is possible to activate the function in time or angle mode. Depending on the mode
selected, a green flag will switch on. If OFF the box will show off with a non-editable grey
background.
4- Saving key: to save parameters and/or return to the previous menu. If you have changed any
parameters, after touching this key, the SAVE CHANGES screen appears and you have to
choose to save or not. After the, you will return to the PROGRAMS menu.
5- Switch button from screen page 2 to screen page 1 of REV & PRE-REV menu.
6- Switch button from screen page 1 to screen page 2 of REV & PRE-REV menu.
7- PRE-REV DELAY: to set a delay before the Pre-Tightening Reverse starts, if PRE-
TIGHTENING REVERSE is on (see #8). Time can be set from 0.3 to 10 secs.
8- PRE-TIGHTENING REVERSE: to allow untightitening before screwing. Time can set
from OFF to OFF a 20.0 sec.
ATTENTION: Pre-Tightening Speed and Torque will be the same as Reverse.
9-
REVERSE TORQUE: to set a reverse torque within the range of the screwdriver selected.
If you’re using an openend wrench attachment, the reverse torque has to be set to MIN
value in order to bring the wrench back to the correct position.
10- REVERSE SPEED: to set any reverse speed value of the screwdriver between the
maximum and the minimum specific speed of every single screwdriver (see table with
technical data).
1
2
3
4
5
6
7
8
9
10