-10-
TROUBLESHOOTING
No flushing
1. No power or mistake connected.
2. Out of electricity.
3. Sensor no working.
1. Check the power connect.
2. Replace batteries.
3. Check connector connect or Replace
sensor.
No flashing
Light indicator no bright
Buzzer alarm
1. The small hole of valve core is blocked.
2. The filter of valve core is blocked.
1. No power or mistake connected.
2. Position Light broken.
1. Out of electricity(the buzzer will sound every 2s).
2. Battery low voltage(the buzzer will sound every
6s).
1. Clean the small hole of valve core with
thin steel wire.
2. Wash the filter of valve core with a brush.
1. Check the power connect.
2. Replace Light indicator.
1. Replace batteries.
2. Replace batteries.
Please make following checks before repair:
Symptoms
Probable causes
Corrective actions
1.
2.
3.
1.
2.
3.
No flushing or poor
flushing
1. Adjusting bolt not fully open
2. Low water pressure.
3. Filter is obstructed.
1. Open the adjusting bolt.
2. Improve water supply.
3. Clean the filter.
1.
2.
1.
2.
1.
2.
1.
2s
2.
6s
1.
2.
1.
2.
1.
2.
3.
1.
2.
3.
IMPORTANT CONSUMER INFORMATION
CONSUMER RESPONSIBILITIES
Do not directly flush the sensor with water. The sensor is an
electronic instrument.
Keep the sensor clean.
Do not use eradicator, abrasive powder or oil, acid or alkali
liquid detergent.
Do not spray air freshener, disinfectant or other kinds of
odious removing, cleaning organic liquid to the sensor directly.
Urinal is designed for use with potable water.
Avoid water that includes a lot of contaminants or acid/lakali
water and impure water.
When AC power unit is connected to 220V AC power supply,
corresponding protective measures should be taken.
Please confirm no water penetration at the connection area of
AC wire, and the connection area is not easy to be affected
by damp.
220V
1356730-T01-B