- 23 -
4
1
2
3
Disassembly / Reassembly
Oil-bath air cleaner
Danger – Attention
Do not blow the paper filter element with compressed air to clean.
Caution – Warning
Check gaskets and replace as necessary.
Check that flange welds are free of defective spots.
When reassembling, tighten the fastening nuts of the air filter to the
intake manifold to 25 Nm.
Exhaust manifold
Danger – Attention
Allow the exhaust manifold to cool before demounting it in order
to prevent scorching and burns.
Make sure that the inside is properly clean and is free from cracks or
breakage.
Always replace the seals between the manifold and the exhaust pi-
pes.
When assembling, tighten the nuts in sequence and gradually be-
fore the final torque to 20 Nm.
Oil-bath air cleaner components
Caution – Warning
Replace if irreparably clogged.
1
Bowl
7
Cover clamp
2
External seal ring
8
Cap
3
Lower filtering element
9
Centrifugal pre-filter
4
Internal seal ring
10
Centrifugal pre-filter clamp
5
Gasket
11
Oil level mark
6
Cover
12
Upper filtering element
(polyurethan sponge)
Note:
Thoroughly clean the lower tank and the metal filter element
using diesel fuel then blow compressed air into them.
The upper filter element in polyurethane foam is cleaned by
washing it in soapy water; after washing, dry completely using
compressed air.
After cleaning refill the engine oil tank up to the indicated level.
See page 17 for the maintenance or replacement instructions.
KD Workshop Manual_cod. ED0053029350_
1° ed
_ rev.
00
Summary of Contents for KD 626/3
