1374956-T01-B
-16-
■
长期不用提示
若需长时间停止使用本产品,请断掉本产品电源;切断本产品与
自来水管路之间的连接,再次使用时
,
为避免伤害事故的发生
,
建
议仔细检查本产品各部件是否处于完好状态,并确认本产品出水
后方可投入使用。
■
给皂功能长期不用提示
若需长时间停止使用给皂功能或不用皂液功能,请将给皂进水管
通水,反复多次启动给皂功能,直到管内液体为清水,接着再把
皂管取出,再次反复启动给皂功能,将皂液管道内的水排干,然
后拔掉皂液泵的对接电线,让其不再启动皂泵;当想再次使用给
皂功能时,只需对接好相应的对接线即可,将进皂管通入专用的
皂液瓶内。
■
机器检查
请定期对本产品进行检查,包括但不限于进水接头、电源线、电
源插头、台面、柜体等;
■
需定期更换风机下方过滤
HEPA
,建议
3-6
个月更换一次;
■
需定期对进水口滤网进行清洗,建议每月进行;
■
需定期对排水管内部污垢进行清洗,建议每月进行;
hose joint, and check whether the joint strainer is clogged.
If clogged, clean it and put into normal use. If the problem is
still existing, please contact the after-sales department for
repair.
■
Prompts for long-term idle
If you will not use this product for a long time, please
disconnect the power supply. Cut off the connection between
this product and tap water pipeline. Before the next use, in
order to avoid injury accidents, it is recommended to check
carefully whether or not all parts of this product are in good
condition. Confirm that water comes out properly before
putting the product into use.
■
Prompts for long-term idle of soap dispenser
If you will stop using the soap dispenser for a long time or
you do not need this function, please make water go through
the soap taking pipe and repeatedly start the function until
the water inside the pipe becomes clean. Then remove the
soap taking pipe and again repeatedly start this function to
drain water from the soap pipe. Then remove the connecting
wires of the soap pump to stop starting the soap pump. When
you want to use the soap dispenser again, you just need to
connect the corresponding connecting wire and insert the soap
taking pipe into the dedicated soap bottle.
■
Inspect the unit
Please regularly inspect this product, including but not limited
to water inlet joint, power cord, power plug, top cover, cabinet,
etc.
■
Regularly replace HEPA filter under the fan. The recommended
period is 3-6 months.
Fan Assembly
ߑুў
HEPA Filter
HEPA
ଋࢡ֘
HEPA Cover
HEPA
त
۴㣜܍व
HEPA
त
ிޞԈ
45°
ՈЈ
HEPA
तչ
HEPA
Hold the HEPA cover with
the hands and rotate it 45°
clockwise and remove the
HEPA cover and HEPA
Remove HEPA and
install a new HEPA
ՈЈ
HEPA
݅
Їޏङ
HEPA
ե
୍ޏЇ
■
Regularly clean the water inlet strainer. It is recommended to
clean every month.
Remove the dirt at the joint of the water inlet pipe
ࢎࡊݎףהङࢡৠࡑ
■
Regularly remove the dirt from inside the drain pipe. It is
recommended to clean it every month.
Nut
夊࠾
Flat Washer
ٵֻ֥
Sealing Ring
إد֥
U-tube U
ֺ