1298232-T01-C
-5-
D.
1.
D. Adjust the hanger
1. As shown in the picture below, firmly press the hanger with
the bolt through the waist-shaped hole.
Fixing Hole
Waist-shaped Hole
2.
3.
2. As shown in the picture below, if the position of the urinal
needs to be adjusted, please take down the urinal and
knock the hanger slightly to adjust its position upwards and
downwards.
3. After the position of the urinal is decided, completely fix the
hanger with the bolt through the fixing holes on the hanger.
Adjust Upwards and Downwards
E. Install the drain and the plastic trap
NOTE:
E.
(
)
1. Put the washer onto the drain and insert it into the hole.
2. Put the gasket and nut on the bottom.
Do not over screw the nut in this step, because it is
to be screwed tight in the next step after the pipe is
installed.
1.
2.
(pre-installed in
factory)
3. Connect the hose with the trap.
4. As shown in the picture, screw the crossbar into the screw
head of filter cap (2-3 turns, as long as it doesn't fall), place
the crossbar into the opening of the connector and swivel
the filter cap to make the crossbar stuck inside the
connector, continue to screw tight.
5. Screw tight the nut of the drain mentioned in step.
3.
4.
2-3
5.
2