1298232-T01-C
USER S GUIDE
Don t use this system until the power is on for 10
minutes.
The sensing distance will be adjusted and the system
will not work during this time.
Working Status
Before powering the system on, chear the unwanted objects
in front of the sensor window lest shortening the sensing
distance.
10
,
Set Working Status
(Only for K-20099T/K-20099T-
C05)
The product comes our factory with:
1. The working status is set as dual-flush. If you want to
cancel the first flushing function, place manual flush stick
adjacent to right side of sensing window for more than 1
second during the 10-minute standby period (Human
presence in sensing range would cause the indicator to
flash fast). The sensor would generate a flushing cycle to
indicate the setup of the sensor has been adjusted to after
use flushing. If the action is not completed during this 10
minute, or you need to restore the working status to
dualflush, plug off the power cord and reconnect the power
supply until the indicator stops flashing and repeat the
above procedures.
2. The diction time is set as 2s to avoid improper function in
narrow toilets, the detection time is automatically set from
2s to 5s.
(
K-20099T/K-20099T-C05)
1.
10
(
)
1
10
2.
2
2
5
,
-8-
Sensing Distance
During the first 10 minutes, when powered on, the system is
in the phase of automatic regulation, and no operation is
required.
10
Deodorizing Flushing
The urinal will take a flush automatically when it’s used 3 or 4
times in 2 minutes.
2
3-4
Replacement of Batteries
(Only for DC)
When out of power, the indicator will flash every 2 seconds
and the sensor will not work until new batteries are supplied.
When replacing batteries, open the cover of battery box and
put in new batteries.
(
)
2
Indicator
