Reassembly
99
19 690 01 Rev. --
KohlerEngines.com
Install Governor Lever, Governor Springs, and
Linkage (Mechanical Governor)
A
C
B
D
E
F
A
Governor Linkage
B
Linkage Spring
C
Speed Control
Linkage
D
Governor Linkage
Lever
E
Governor Lever
F
Governor Spring
1. Connect speed control linkage to governor linkage
lever.
2. Connect governor linkage and linkage spring to
throttle body and to governor lever.
3. Connect governor spring to governor lever and
governor linkage lever.
4. Install governor lever onto governor shaft but do
not tighten nut.
Install Oil Cooler (if equipped)
NOTE: New hose clamps are recommended for
reassembly, or if clamps have been loosened
(expanded) several times to avoid leakage.
1. Connect hoses between oil cooler and oil pan.
Secure with new clamps.
2. Orient new clamps as noted in disassembly.
3. Install screws to secure oil cooler to blower
housing. Torque top screw (M5) to 5.6 N·m
(50 in. lb.) and bottom screw (M6) to 4.8 N·m
(46 in. lb.).
Install Throttle Body Bracket
Loosely install throttle body bracket with screws. Do not
tighten at this time.
Install Intake Manifold/Throttle Body Assembly
Torque Sequence
1
3
4
2
1. Carefully place intake manifold assembly onto
engine.
Throttle body bracket must be behind all wires in
harness.
2. Slide intake gaskets between intake ports and
manifold. Torque intake manifold screws, using
sequence shown, to 16.0 N·m (142 in. lb.).
Manifold screws must be torqued while throttle body
bracket is loose.
3. Torque M6 throttle body bracket screws to 10.2 N·m
(90 in. lb.); M8 screw to 16.0 N·m (142 in. lb.).
Summary of Contents for Command Pro ECV850
Page 102: ...KohlerEngines com 19 690 01 Rev 102...
