![Kohler Command PRO CH749 Service Manual Download Page 73](http://html1.mh-extra.com/html/kohler/command-pro-ch749/command-pro-ch749_service-manual_1988101073.webp)
6.3
Section 6
Lubrication System
6
Oil Drain Plug Oil Filter Side
Figure 6-6. Location of Oil Drain (Oil Filter Side).
3. Reinstall the drain plug and torque to
13.6 N·m
(10
ft
. lb.)
.
4. Remove the
fi
ll cap or use the dipstick
fi
ll tube to
fi
ll the crankcase with new oil of the proper type
to the
F
or
FULL
mark on the dipstick. See Figure
6-7. Recheck oil level before adding more oil.
Figure 6-7. Removing Oil Fill Cap.
5. Reinstall the oil
fi
ll cap and dipstick securely.
Changing Oil Filter
Replace the oil
fi
lter
at least every other oil change
(every 200 hours of operation).
Always use a genuine
Kohler oil
fi
lter. Replace the oil
fi
lter as follows. See
Figure 6-8.
Figure 6-8. Removing Oil Filter.
1. To keep dirt, debris, etc., out of the engine, clean
the area around the dipstick; remove the dipstick.
Remove the oil drain plug on the starter side or
the drain plug oil
fi
lter side. Allow ample time for
complete drainage. See Figures 6-3, 6-5 and 6-6
2. Reinstall the drain plug and torque to
13.6 N·m
(10
ft
. lb.)
.
3. To keep dirt, debris, etc., out of the engine, clean
the area around the oil
fi
lter; remove the oil
fi
lter.
See Figure 6-8.
4. Wipe the surface where the oil
fi
lter mounts.
5. Place a new
fi
lter in a shallow pan with the open
end up. Pour new oil, of the proper type, in
through the threaded center hole. Stop pouring
when the oil reaches the bo
tt
om of the threads.
Allow a minute or two for the oil to be absorbed
by the
fi
lter material.
6. Apply a thin
fi
lm of clean oil to the rubber gasket
on the new
fi
lter.
7. Install the oil
fi
lter to the
fi
lter adaptor or oil
cooler. Refer to instructions on the oil
fi
lter for
proper installation.
8. Remove the
fi
ll cap (see Figure 6-7) or use the
dipstick
fi
ll tube to
fi
ll the crankcase with new oil
of the proper type to the
F
or
FULL
mark on the
dipstick. Recheck oil level before adding more oil.
(Refer to
Check Oil Level
Check Oil Level
.)
9. Reinstall the oil
fi
ll cap and dipstick securely.
Summary of Contents for Command PRO CH749
