81
Disassembly/Inspection and Service
66 690 14 Rev. A
KohlerEngines.com
Governor Gear Assembly
Governor Shaft Press Depth Details
C
B
A
A
Gear Shaft
B
19.40 mm (0.7638 in.)
C
34.0 mm (1.3386 in.) 33.5 mm (1.3189 in.)
Governor gear assembly is located inside closure plate.
If service is required, refer to these procedures.
Inspection
Inspect governor gear teeth. Replace gear if it is worn,
chipped, or if any teeth are missing. Inspect governor
weights. They should move freely in governor gear.
Disassembly
NOTE: Governor gear is held onto shaft by small
molded tabs in gear. When gear is removed from
shaft, these tabs are destroyed and gear must
be replaced. Therefore, remove gear only if
absolutely necessary.
Governor gear must be replaced once it is removed from
closure plate.
1. Remove regulating pin and governor gear assembly.
2. Remove locking tab thrust washer located under
governor gear assembly.
3. Carefully inspect governor gear shaft and replace it
only if it is damaged. After removing damaged shaft,
press or lightly tap replacement shaft into closure
plate to depth shown.
Reassembly
1. Install locking tab thrust washer on governor gear
shaft with tab down.
2. Position regulating pin within governor gear/
fl
yweight
assembly and slide both onto governor shaft.
Oil Pump Assembly
Oil pump is mounted inside closure plate. If service is
required, continue with Disassembly, Inspection, and
Reassembly.
Disassembly
1. Remove
screws.
2. Lift oil pump assembly from closure plate. Remove
outer gerotor gear from closure plate.
3. Ensure ball and spring remain installed in pressure
relief hole of closure plate. If ball and spring fall out
of pressure relief hole, see reassembly for correct
installation.
4. Remove oil pump cover O-ring from groove in
closure plate.
Inspection
Inspect oil pump housing, gear, and rotors for nicks,
burrs, wear, or any visible damage. Inspect oil pump
cover O-ring for cuts, nicks, or any visible damage. If any
parts are worn or damaged, replace oil pump assembly
and/or O-ring. Check oil pickup screen for damage or
restriction, replace if necessary.
Reassembly
1. Lubricate outer gerotor gear with oil. Install outer
gerotor gear through shaft of oil pump, around inner
gerotor gear. Matching molding dots on inner and
outer gerotor gears is not necessary and will not
a
ff
ect oil pump e
ffi
ciency.
2. Reinstall ball, then spring into pressure relief hole in
closure plate.
3. Reinstall O-ring into groove in closure plate; make
sure it is fully seated in groove.
4. Install oil pump inserting center shaft into
corresponding recess in closure plate. Apply
consistent downward pressure to oil pump cover,
compressing oil pressure relief spring and start
screws. Secure oil pump by torquing screws (in no
speci
fi
c sequence) to 7.9 N·m (70 in. lb.).
5. After torquing, rotate gear and check for freedom of
movement. Make sure there is no binding. If binding
occurs, loosen screws, reposition pump, retorque
screws and recheck movement.
Remove Camshaft
Remove camshaft and shims.
