101
Reassembly
66 690 14 Rev. A
KohlerEngines.com
Install Starter Plate and Starter Assembly
1. Install starter plate to crankcase. Install mounting
screws and torque screws to 15.3 N·m (135 in. lb.).
2. Mount starter to adapter plate using screws.
3. Make sure starter is square to
fl
ywheel, and torque
screws to 15.3 N·m (135 in. lb.).
4. Attach leads to appropriate starter solenoid
terminals.
Connect Oxygen Sensor
1. If oxygen sensor was removed from mu
ffl
er (OEM
supplied), reinstall it and torque to 18 N·m (159 in.
lb.).
2. Connect oxygen sensor to wire harness.
Install Oil Filter and Fill Crankcase with Oil
NOTE: Make sure both oil drain plugs are installed and
torqued to speci
fi
cations to prevent oil leakage.
1. Install oil drain plug(s). Torque plug(s) to 13.6 N·m
(10 ft. lb.). If oil drain valve is used, make sure valve
body is closed and cap is on.
2. Place
new
fi
lter in shallow pan with open end up. Fill
with new oil until oil reaches bottom of threads. Allow
2 minutes for oil to be absorbed by
fi
lter material.
3. Apply a thin
fi
lm of clean oil to rubber gasket on oil
fi
lter.
4. Refer to instructions on oil
fi
lter for proper
installation.
5. Fill crankcase with new oil. Level should be at top of
indicator on dipstick.
6. Reinstall
oil
fi
ll cap/dipstick and tighten securely.
External Engine Components
A
C
D
E
I
G
F
H
B
A
Dipstick
B
Spark Plug Lead
C
Electric Starter
D
Starter Plate
E
Oil Drain Plug
F
Radiator Drain Plug
G
Oil Filter
H
Radiator Cap
I
Oil Fill Cap
