Kofax Image Products VirtualReScan 4.0, Installation Manual

Page: 49 / 116

VRS Installation Guide 37
Attach the Scanner
Your scanner may already be attached to your computer. If not, you can follow the
procedure in this section to ensure that the scanner and computer are properly
connected. Verify that you are using a Kofax-certified scanner cable. If necessary, you
can select the Scanner Configurator from the Kofax Web site at www.kofax.com to
verify that you have the appropriate scanner cable.
X
To connect the scanner to your computer
1
Make sure to power off the scanner and computer and unplug the power cord
for both.
2
Attach the scanner cable to the scanner and to the appropriate port (SCSI, USB,
or FireWire) on your computer.
3
Plug in the power cord for your scanner and start it.
4
Plug in the power cord for your computer and then start it. Windows may
launch the Found New Hardware Wizard. If so, proceed to
Resolve the Found
New Hardware Wizard Event on page 42 and follow the instructions. Otherwise,
VRS will be ready to use once your scanning application is installed.
TWAIN Installations
To install the TWAIN driver for a VRS-certified scanner, follow the manufacturer-
provided TWAIN driver installation instructions for your scanner. The TWAIN driver
can be installed before or after the VRS software installation. To install a non-certified
(compatible) VRS scanner, refer to
VRS Scanners: Certified vs. Non-Certified on page 4.