43
C35-FC
19. Device Reset
In the event C35-FC becomes inoperative, the device can be reset using the manual reset
switch, which is located on the bottom right hand corner of the device. Gently insert a
thin object into the opening. The device should reboot through the normal boot menu.
Note: Do not touch the display during the boot menu to avoid inadvertently performing a
factory reset.
20. Factory reset
Caution:
All stored data will be deleted. This should only be used in situations where all
parameters need to be reset to their default values.
The C35-FC has its factory default function built into the boot menu. To perform a factory
reset:
1.
Reset the device by following procedure described in chapter
Device reset
2.
When the device enters the boot menu, touch and hold the screen untilit reaches
the
“Press to reset all parameters” section.
3.
The device will boot up with all the default parameters.
NOTE:
As the device has been reset to factory settings, please see chapter
6. First boot
up and commissioning instructions.
21. Calibration of resistive touchscreen
The resistive touch screen has been calibrated during the production process. In the
unlikely event that the touch screen needs to be recalibrated, please follow these steps:
1.
Reset the device by following procedure described in chapter Device Reset
2.
When the device enters the boot menu, touch and hold the screen until it reaches the
“Touch screen (press to calibrate)…” message, and follow the instructions on the screen.
3.
Once you enter calibration, touch the screen to start procedure.
4.
Press the red dot on the screen in each corner of the screen.
5.
Once all four dots have been tested, the calibration procedure ends. If this needs to
be repeated, follow steps 1-4 again.
Figure 19.1.