MDC-2200/2500 Series
Chapter 5 Detailed setup and additional menu
0092625002-06
5-23
5.2.5.9 AIS diagnosis
This item is used to diagnose of the operation of AIS printed circuit board.
5.2.5.10 Version
This item is used to display the software version of this device, operation panel, ATA, AIS
(optional) and map.
5.2.6 Option
Refer to “4.7 Setup of inter-switch functions” (4-11).
5.2.7 Initial
This menu is displayed only in detailed menu during pre-heating or standby screen.
This menu cannot be operated during transmission.
5.2.7.1 Readout of setup items
IMPORTANT: Setting values must be saved beforehand.
Readout setting value previously saved in item (5.2.7.2) Setup save operation.
It is used to recover setting values in case that radar operation becomes abnormal and
unrecoverable etc.
Saved setting value is read and set by proceeding [SETUP LOAD] => [EXEC] => [ENT] key
operation.
Note: Saved setting values of previous version software can not be readout after change of device
software version.
5.2.7.2 Setup save
This operation enables to save setting values when initial setup operation is complete or setting
alternation or data input (mark, navline, alarm2 data etc.) are performed.
When operation of main unit becomes abnormal and the setup values can not be recovered, setup
values can be recovered by using “Readout of setup items” shown in above item (5.2.7.1).
Current setup value is saved by [SETUP SAVE] => [EXEC] => Press [ENT] key.
5.2.7.3 External load
This command is for maintenance by dedicated tool in PC.
This is to load the preset values saved in PC by (5.2.7.4) External save into radar.
This brings the values back to the setting last time it was saved.
Summary of Contents for MDC-2200 series
Page 1: ......
Page 67: ...MDC 2200 2500 Series Chapter 5 Detailed setup and additional menu 0092625002 06 5 5 ATA EPA ...
Page 123: ......
