DryView 8600 User Guide
5-12
8186546 2000 March Rev. B
Clearing the Developer or Exit Jam
1. Open the top cover and unlatch the developer assembly cover (see Figure 5-6).
2. Open the developer assembly cover and allow time for the developer to cool.
3. Pull to remove any jammed film. (Caution: The film may still be hot.) To aid in
removing the film, you may rotate the drum by turning the gear on the left side of
the drum.
4. Close and latch the cover.
8300-35A
8300-34A
8300-33A
1
8300-32A
3
4
2
Figure 5-6. Clearing Film Jams from the Developer and Exit Areas
Note
Check to see that all jams reported by error messages have been corrected. If
additional error messages have occurred, they may recur after the power-up
self test. If they do, refer to Table 5-1 for instructions.
Summary of Contents for Kodak DryView 8600
