Kodak Kodak DryView 8600, User Manual

Page: 52 / 77

Section 5 – Troubleshooting
5-5
2000 March Rev. B 8186546
Message Operator Action
NON-VOLATILE RAM FAILURE (97)
CALL SERVICE – PRESS ENTER TO
CONTINUE
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
NO RESPONSE FROM KEYPAD A (B) (78)
PRESS ENTER TO CONTINUE
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
NO RESPONSE FROM INPUT A (B)
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
PERFORMING CALIBRATION
None.
PERFORMING SELF-TEST
None.
POWER DISTRIBUTION FAILURE (49)
TURN OFF IMAGER – CALL SERVICE
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
PRINT JOB LIST FULL (86)
PRESS ENTER TO CONTINUE
Wait until some films have printed
before sending more images to print.
REGULATING TEMPERATURE
Imager adjusting temperature. If not
completed in 45 minutes, call service.
REMOVE FILM FROM EXIT AREA (28)
INSERT FILM SAVER TO REMOVE FILM TRAY
Insert the film saver. Raise the cover
and remove film from the exit area.
Close cover and remove the film saver.
Press Enter to continue.
REMOVE FILM SAVER (31)
Remove the film saver from the tray.
REMOVE FILM TRAY (40)
Insert film saver and remove film tray.
REMOVE, LOAD, AND INSERT FILM TRAY (12)
Remove the film tray, load film, and
re-install the film tray.
REMOVE, LOAD, AND INSERT FILM TRAY (30)
PRESS ENTER WHEN READY TO REMOVE
TRAY
Press Enter. Remove the film tray, load
film, and re-install the tray.