DryView 8600 User Guide
3-2
8186546 2000 March Rev.B
Producing a Print from a Host Modality
After warmup and calibration, the DryView 8600 Laser Imager is ready to print.
Print commands are issued and controlled from the digital host modality.
Producing a Print Using the Optional Keypad
Note
The following procedure does not apply if the DryView 8600 Laser Imager is
being used in a DICOM network.
1. Power on the imager.
2. Wait for the green Imager Ready (1) indicator to illuminate.
3. Press Select (2) repeatedly until the desired number appears on the Format
Selected indicator (3).
Note
You can select a format only if no images are acquired or all acquired images
are printed.
4. To start image acquisition, press Acquire (4) or use the optional foot activated
switch (Foot Switch).
If acquisition is successful, the Images Acquired (5) indicator increments
and one short beep is sounded.
If acquisition is unsuccessful:
–
The audible alarm of three short beeps sounds (if set to ON).
–
The Images Acquired (5) indicator does not increment.
–
The Check Imager (6) indicator lights
–
An associated message appears on the local panel.
Note
The failure indication is visible only at the keypad where acquisition was
unsuccessful. After an unsuccessful attempt, you should try to acquire an
image again. If the acquire is successful, the Check Imager (6) indicator turns
off and the Images Acquired (5) indicator increments and one short beep is
sounded.
5. Repeat step 4 until all images are acquired.
Summary of Contents for Kodak DryView 8600
