The Basics
35
Contents
Back
Next
Index
Connecting the DCS Pro Back Plus to the
Camera Body
1
If using a MAMIYA RZ67 PRO II, you must first
attach a DCS Pro Back Plus MAMIYA
interface plate
(page 34)
. (This is not
necessary with the HASSELBLAD 555ELD,
553ELX, 503CXi or 503CW.)
2
Remove the protective body cap from the DCS
Pro Back Plus. (Pull the bottom off, then lift the
top slightly to clear the release button.)
IMPORTANT:
Do not touch or strike the exposed IR filter (or
anti-aliasing filter) or set it down on a surface.
3
Using isopropyl alcohol on a lint-free lens
cleaning tissue, clean the contact pads on the
DCS Pro Back Plus and the contact pins and
locating posts on the camera body.
IMPORTANT:
Do not connect a power source to the DCS Pro
Back Plus until it is connected to the camera
body or the MAMIYA Interface Plate.
