Kobold NRM, Operating Manual

Page: 18 / 52

NRM
page 18 NRM K06/0422
8.2.2 Menu structure
Main menu
BASIC SETUP Parameter group of the basic measurement parameters
OUTPUT SETUP Parameter group of the output parameters
OPTIMIZATION Parameter group for measurement optimization settings
CALCULATION Calculations
SERVICE Service functions, calibration, test and simulation
8.3 Programmable features description
8.3.1 Basic measurement settings
8.3.1.1 Default unit system
Parameter: P00: c, where c: 0, 1. Default value: EU
Path: BASIC SETUP / UNITS / ENGINEERING SYSTEM
Description: This should be configured as the first step of the
programming.
Here you can choose the default unit system:

EU European unit system

US Anglo-Saxon / American unit system
8.3.1.2 Dimension of the fault unit system
Parameter: P00:b, and P02:b, or P02:c Default value: mm, m
3
,
t
Path: BASIC SETUP / UNITS / ENGINEERING UNITS
Description: The dimension of the selected default unit system can
be specified in this menu. The selected measurement
mode here will define the primary measured value and
the displayed value, furthermore it will be the source for
the current output:

BASIC UNITS (m, cm, mm, ft, inch )

VOLUME / FLOW UNITS (m 3 , l, ft 3 , gallon )

MASS UNITS (t, t)
If the dimension is modified, the device resets all the parameters after a warning
message.
8.3.1.3 Primary value mode
Parameter: P01: b a Default value: DIST
Path: BASIC SETUP / PV MODE
Description: This mode determines the primary value and the
displayed value. It also determines the value which will
be proportional to the output current.

DISTANCE

LEVEL

VOLUME

MASS