0900455 Rev: F (06/02)
Page 9 of 20
This selection shows which pump is being used to count loads.
Always enter the last pump in the system that will receive a
signal. Use the INC/DEC buttons to choose the number, then
press ENTER. Press MENU
to continue.
IMPORTANT: The dispenser memory must be cleared when
programming a new dispenser.
DISPENSER
SETUP
1
This selection allows you to clear pump volumes, flow rates and
formula names in the dispenser and will reset the system to the
factory default setting.
CLEAR SETTINGS ?
YES OR NO
If you pressed YES, this message will appear, indicating
that the dispenser memory is actively being cleared.
CLEARING
MEMORY ....
This selection shows which pump will be defeated if the BLEACH
DEFEAT button is pressed. Use the INC/DEC buttons to choose
the number, then press ENTER. Press MENU
to continue.
BLEACH PUMP = X
INC/DEC
ENTER
IMPORTANT: The load count pump must receive a signal on
every washcycle for the system to operate correctly (even if the
load count pump will not actually dispense chemical for the
formula selected).
When the load count pump receives a signal, the load counter is
incremented as well as resetting bleach defeat, formula levels,
and signal lockout in preparation for the next washcycle.
This setting is critical when using Drain Mode to maintain proper
injection sequence. Normally you will set the load count pump to
correspond with the last drain signal that will be received during
the formula, however there may be additional drain signals that
occur after the last pump has injected. In this situation, a fictitious
pump can be assigned to act as a load count pump.
LOAD COUNT P= X
INC/DEC
ENTER
This selection allows you to choose between US, Metric, or
Imperial units of measure. Use the INC/DEC buttons to choose
the desired setting, then press MENU
to continue.
UNITS = US
INC/DEC
This selection allows you to choose seconds or minutes as the
delay time unit of measure. Use the INC/DEC buttons to choose
the desired setting, then press MENU
to continue.
DELAY UNITS=SEC
INC/DEC
Some injections only need to be delayed for a few seconds while
others need much longer times. Choose the setting best suited for
your particular installation.
