Page 12 of 20
0900455 Rev: F (06/02)
This selection allows you to customize formula names (up to 14
characters). Use the SCROLL and INC/DEC buttons to choose
the formula number on the top line, then press ENTER ... the
current name of that formula will appear on the bottom line. Press
SCROLL to move the cursor down to the bottom line, then use
the SCROLL and INC/DEC buttons to establish a formula
name ... press ENTER to log the data into memory. Repeat this
step for other formulas, then press MENU
to continue.
FORMULA 01
FORMULA 01
This selection allows the “main” access code to be changed. Use
the SCROLL and INC/DEC buttons to establish the new code
number, then press ENTER to log the data into memory. Press
MENU
to continue.
ACCESS CODE=000
INC/DEC
ENTER
This selection allows the “user” access code to be changed. Use
the SCROLL and INC/DEC buttons to establish the new code
number, then press ENTER to log the data into memory. Press
MENU
to continue.
USER ACCESS CODE
=000
INC/DEC
ENT
If access codes are changed, keep a record of the changes in a
safe place, in the event that access codes are forgotten. If the
record of code changes becomes misplaced, contact Knight.
This selection allows you to change the display name that shows
in the window of the Remote Control (up to 14 characters). Press
SCROLL to move the blinking cursor down to the bottom line,
then use the SCROLL and INC/DEC buttons to establish the new
display name ... press ENTER to log the data into memory.
DISPLAY NAME
Check the dispenser circuit board to determine if there are output
connections for pumps 7 and 8. If there is, choose ENABLE using
the INC/DEC buttons. If the circuit board does not have
connections for pumps 7 and 8, make sure this menu selection is
set to DISABLE.
PMP 7 & 8 = DISABLE
INC/DEC
This selection allows you to turn the drain mode ON or OFF. Use
INC/DEC to make your selection, then press MENU
to
continue.
DRAIN MODE = ON
INC / DEC
This selection allows you to select if the drain signal is to be
NORMAL or INVERTED. Use INC/DEC to make your selection,
then press MENU
to continue.
DRAIN SIG = NORMAL
INC / DEC
