0900455 Rev: F (06/02)
Page 15 of 20
NOTE: Programming formula settings is not necessary for “relay
mode” operation (pumps run for as long as their signal is present
in RELAY MODE). See Relay Mode section for more details.
To view existing data, use the SCROLL and INC/DEC buttons to
choose the desired formula/level/pump, then press ENTER while
the blinking cursor is on the top line. To input new data, repeat
the previous step, then use the SCROLL and INC/DEC buttons to
establish the volume and delay time, then press ENTER while the
cursor is on the bottom line. Press MENU
to continue.
FORM O1 L 1 P 1
V 000.0 OZS D000
FORMULA
SETTINGS
3
If you chose VOLUME (from CALIBRATE PUMPS menu)...
To view other formula/level/pump information, use the SCROLL
and INC/DEC buttons to pick your choice, then press ENTER
while the blinking cursor is still on the top line. If you wish to
change the data, or input it without running pumps, repeat the
previous step, then use the SCROLL and INC/DEC buttons to
establish the run time and delay time, then press ENTER while
the blinking cursor is on the bottom line.
FORM 01 L1 P1
T 000 SEC D000
Use the SCROLL and INC/DEC buttons to choose the formula,
level, and pump number, then press ENTER to start the pump.
When the desired amount of product has been dispensed, press
ENTER again to stop the pump. The run time is tracked
automatically and the display below will appear…
NOTE: You can get to the following display without having to run
pumps by pressing MENU
from this menu selection.
FORM 01 L 1 P 1
ENT = START/STOP
If you chose TIME (from CALIBRATE PUMPS menu)...
If this message appears, it indicates an attempt to
program a volume that exceeds the run time limit of 255
seconds (as calculated by the flow rate of the pump).
MAX VOLUME
IS 255 SEC
If this message appears, it indicates an attempt to
program a delay time that exceeds 255 seconds (or
minutes, as selected in the DISPENSER SETUP menu).
MAX DELAY
IS 255 SEC
This selection is for use with drain mode only and allows you to
enter the drain assignment for each pump and formula. Use the
SCROLL and INC/DEC buttons to choose formula, level, and
pump numbers, then use the SCROLL button to move the cursor
to the bottom line to change the drain assignment. Then press
ENTER while the blinking cursor is still on the bottom line. Repeat
this for each pump on every level in each formula used.
FORM 01 L 1
P1
DRAIN COUNT = 000