13
Remove power plug. Cordon off the repair area as far as it is required.
After completing maintenance work and rectifying any faults, install all safety devices and verify
that they are fully functional.
2.4.10 Structural alterations to the circular knife grinding attachment
Modifications, retrofitting or rebuilds of the circular knife grinding attachment are not allowed
without the permission of the manufacturer. This also applies for installation and configuration of
the safety devices.
Any conversion work requires the written permission from KNECHT Maschinenbau GmbH.
Immediately replace any machine parts that are not in a serviceable state.
Use only original replacement and wear parts. When using external parts, it cannot be guaranteed
that they are constructed and manufactured to be suitable and safe.
2.4.11 Cleaning the circular knife grinding attachment
Properly handle any cleaning agents and materials used and dispose of them in an environmentally-
friendly manner.
Dispose of the wear parts and replacement parts in a safe and environmentally-friendly manner.
2.4.12 Lubricants / oils and greases
When using oils and greases, follow the safety regulations applicable to the product. Comply with
the special regulations for the foodstuffs sector.
2.4.13 Relocation of the grinding machine with circular knife grinding attachment
Disconnect the grinding machine with circular knife grinding attachment from any external cur-
rent supply, even if slightly adjusting its position. Before restarting the grinding machine, properly
connect it to the current supply.
When loading or unloading, only use suspension devices and load suspension devices with
sufficient load-bearing capacity. Designate suitable lifting devices for the lifting process.
Ensure that only persons authorized to carry out this work are located where the machine is
unloaded and installed.
Use only a suitable transport vehicle with sufficient carrying capacity. Secure loads safely. See also
chapter 4 of the operating instructions for the S 200 Universal Wet-Sharpening Machine. When
recommissioning, do so only in accordance with the operating instructions.
2. Safety
