SDKIT17-230/734STD
Installation and Operation Manual
PG 27/30
REV: BETA (4/13/2020)
10.5.
Install Horn Button
10.5.1.
Find a suitable location for Horn B
utton (i.e., in dash, center console, etc.); verify location has 1”+ of
clearance behind for terminal connectors. Mark location for drilling.
10.5.2.
D
rill a 3/4” hole at location. Route
Horn Button wires to hole then slide push-button retaining nut over
wires and connect wiring. Install Button into hole and tighten retaining nut from backside.
Figure 15
–
Horn Button Installed in Dash and OE Upfitter Switches (Shown in example vehicles)
NOTE:
FOR VEHICLES WITH OE/FACTORY UPFITTER SWITCHES:
If your vehicle is equipped with factory upfitter (i.e., auxiliary) switches, you may elect to use them for
your Kleinn Air Horn kit; consult Owner
’
s Manual, or dealership for further instructions on what wire
terminals/fuse block location to use and programming required.
10.6.
Connect Pressure Switch
10.6.1.
Route wiring, as desired to Air Tank and connect to Pressure Switch, per wiring diagram.
NOTE:
Either pressure switch wire can be connected to Relay or Ignition; they are identical.
10.7.
Connect Air Compressor
10.7.1.
Route wiring, as desired to Air Compressor and connect, per wiring diagram.
10.8.
Connect Air Horn Solenoid(s)
10.8.1.
Route wiring, as desired to Air Horn and connect to Solenoid(s), per wiring diagram.
NOTE:
Either Air Solenoid wire can be connected to Power (PWR) or Ground (GND); they are identical.
10.9.
Secure Wiring to Vehicle
10.9.1.
Insert all wiring into included wire loom and ensure loom is away from all sharp edges, hot/moving vehicle
parts (i.e., exhaust, engine, radiator) and fasten securely to vehicle using supplied zip ties, or equivalent.
End of Section
Terminator Horn Button
OE Upfitter Switches
