SDKIT17-230/734STD
Installation and Operation Manual
PG 23/30
REV: BETA (4/13/2020)
9.5.
Install Air Tank Fittings on Air Tank & Connect Air Tubing
9.5.1.
If Air Tank is already installed in vehicle, it may be required to remove Air Tank to gain enough space.
9.5.2.
If Air Tank has not been installed yet, assemble Fittings during bench assembly.
9.5.3.
Install Air Fitting #F1 (or #F2/F3) into port shown in below illustration.
9.5.4.
Apply 1-2 drop of Kleinn Air Horn juice on end of each male thread before installing Fittings, hand tighten,
then further tighten 1/4-1/2 Turn with wrench.
Adjust angle of Fitting towards rear as shown below, by
tightening further or allowing Air Horn Juice to cure in position.
NOTE:
Follow directions in SDKIT17-230/734 Technical Manual for removal/install of Air Tank
Figure 10
–
Installing Air Fittings onto Air Tank (Exploded view shown as if installed in Vehicle)
F3
F1
F2
Use large Port
on Pass Side
Connect Air
Tubing
