KiSS ORCA SPIRIT, Manual

Page: 32 / 124

32 MSL 72.161 Jetsam/Orca Spirit manual R.5
CARE FOR YOUR FISCHER CONNECTOR AND THE CABLES
Having Fischer connectors on a rebreather display system is a convenience that many divers enjoy. While a lot of
maintenance is not required, some care is important in order to ensure that they operate properly.
The Fischer connector port is water ght and any water that gets in to the port cannot harm your head, computer, or
HUD. However, should sea water get inside the port or the ends of your linking cable, flush them with fresh water as
soon as possible a erwards then leave them to dry completely BEFORE refi ng the cap.
Regular maintenance should include:
1. Inspect the connectors and look for any signs of corrosion; parts will start to turn green.
2. If you see green/corrosion, rinse the connectors briefly with white vinegar and use a fine toothbrush to remove the
build‐up. Rinse well and let dry completely before refi ng the protec ve caps.
3. Keep the inner O‐ring lubricated by either applying a SMALL amount of grease on the metal end of the cable end
that slides into the computer Fischer connector to lubricate the inner O ring of the bulkhead connector. Filling the
connector with food grade mineral oil once a year will also work. This will serve to improve the seal and make the
connec on more reliable. If you have a sensor which is reading erra cally, this could be a solu on.
4. If you use the mineral oil, drain any excess prior to replacing the caps.
5. Use the protec ve caps. The caps will help keep your connectors clean, keep the lubricant in and any debris and
water out.
Remember, the cleanliness of the contacts is essen al to the integrity of the link. Following these simple steps will en‐
sure that your system works properly. Look a er your cable and connectors and they will look a er you.
Also, be certain that you are using the correct Fischer cable for the computer that you are diving. There are some that
are not compa ble with all computers.