Page 57
Step 3
: Carefully loosen the circuit board from the top half of the case, turn the assembly over and move
the top half of the case back just enough off of the circuit board to expose the jumper plugs as shown
below. Be very careful not to kink or otherwise stress the cable which attaches the display screen to the
circuit board. To reset a jumper for the desired voltage level, pull its shunt off of the pins and reinstall it
on the pins as indicated by the values printed on the circuit board. In the picture below, the analog
ports are set for +3.3V and the digital ports for +5V.
Step 4
: Turn the top of the case back over and carefully reinstall the circuit board, then replace the
Phillips head screw.
Step 5
: Reattach the battery and close up your KIPR Link, paying particular attention that the battery
cables are clear and the speaker is back in place, then reinstall the 4 Torx screws that hold the bottom
half of the case to the top.
Step 6
: Boot your KIPR Link to verify it is still working.
Analog rails
jumper plug
Digital rails
jumper plug
Display screen cable
Analog and digital ports
