41
CHANGING THE POWER NOZZLE BELT (cont)
Slide off the old belt and replace with a new one.
➤
4
Operating/Maintenance Tips
Make sure the Brush Roll Bristle Height Adjustment setting
(1, 2, or 3) is the same on both ends as when the brush was
removed. See below for discussion of the Brush Roll Bristle
Height Adjustment (1, 2, or 3). Place the belt and Brush Roll back
into the nozzle. One of the plastic Brush Roll ends is larger than the
other, thus the Brush Roll will only fit in the nozzle one way.
Then center the belt on the Brush.
➤
Replace the Rug Plate by placing it on the front of the bumper
first and then pulling it over the bumper on the rear of the Power
Nozzle
. Secure the Rug Plate using the two latches that hold
it in place.
➤
Using the handle on the Belt Lifter
⑳
, turn it to the left (counter-
clockwise) until the red arrows line up. This will stretch the belt
in preparation for returning the nozzle to the Sentria® system.
Now you are ready to re-attach the Power Nozzle and re-engage
the belt.
❏
6
5
7
