36
USING THE CARPET FLUFFER
Your Kirby® Floor Buffer can also be used as a Carpet Fluffer to reset
the nap on a matted-down carpet.
Before fluffing the carpet, raise the nozzle all the way up by
pushing the Toe-Touch Control Bottom Pedal
⑨
all the way down.
Place the cleaner on the carpet to be fluffed. Plug in the Power Cord.
Disengage the Tech Drive® power assist by pressing on the gray “N”
side of the Tech Drive N/D Pedal
⑪
.
➤
Holding onto the handle firmly, start the cleaner by pressing
the ON switch.
➤
HARD FLOOR PAD
See page 13 for set-up and use of the Hard Floor Pad.
❏
1
2
Optional Accessories
Lower the Carpet Fluffer Nozzle one notch at a time by pushing
the Toe-Touch Control Upper Pedal
⑧
. The instant the brush
contacts the carpet, stop lowering the brush.
➤
Then engage Tech Drive® power assist by pressing down on the
red “D” side of the “N/D” Pedal. You are now ready to fluff the
carpet by pushing the cleaner back and forth over the carpet.
NOTE: • Lowering the brush too far on cable yarn type carpets may
cause the carpet to fuzz. Do not fluff delicate carpets.
• The belt should not be stretched when stored for an extended
period. Make sure the green arrows line up for storage.
❏
3
4
