Kipp & Zonen LAS, Instruction Manual

Page: 67 / 75

66
Combilog 1020+
U 3.xx
Date: dd.mm.yy
Time: hh.mm.ss
LOG: 0 253kb
free: 27d
PCMCIA: 1904kb
free: 100d
Chan 1
xx [units]
Chan x
xx [units]
Service mode
normal
Weather station
Adr. : 1 19200N
Auto. off: OFF
LEDs: ON
Scan Rate: 4s
Averaging: 10m
Display Contrast
adjust?
Input
disable
Combilog 1020+
U 3.xx
Figure 42: Main menu (left) and Configuration menu (right) of COMBILOG data logger.
Step 1: Enable the press/rotary knob of the data logger
For safety reasons the press/rotary knob of the dat alogger is disabled (automatically done by the
COMBILOG data logger), meaning that part of the configuration menu cannot be accessed. In order to
enable this knob, go to “
COMBILOG 1020+ ” of the main menu by rotating the press/rotary knob. Press
the knob briefly. The configuration menu will be accessed. Rotate the knob until “ Input disabled ”
appears on the display (see Figure 42). Again press the knob briefly. Rotate the knob again until
“
Input < enable > ” appears and press the knob briefly. The knob is now enabled to modify all settings
of the data logger manually. Go back to the main menu, by pressing the knob for about 1 second, you
will return to the main menu (“
COMBILOG 1020+ ” appears).
Note that the knob will be disabled again after 30 seconds if no operations are performed on the knob.
Input
< disable >
Input
< enable >
Input
disable
Figure 43: Lock/Unlock of the press/rotary knob of the COMBILOG data logger.