Kipor IG6000, Service Manual

Page: 16 / 38

12
2.8.6 Engine stops after starting
Check the engine oil level and check if
oil level alarm activates when rotation
stops
→oil level
alarm
Add oil and restart the engine
↓sufficient oil
Check the fuel in fuel tank
→no fuel
Add fuel and restart the engine
↓sufficient fuel
Check for operation of fuel switch and
blockage in fuel filter
→clogged
Clean the fuel switch and filter
↓not clogged
Check for blockage of fuel hoses
→clogged Clean or replace the hoses
↓not clogged
Check for carburetor fuel delivery
→not
fueling
Disassemble and clean
↓normal fuel flow
Check the intake gasket and the sealing
of carburetor heat-insulation block
→abnormal
Tighten the nuts securely, replace the
gasket or heat-insulation block
↓normal
Measure the cylinder compression
→abnormal
1. Check the valve clearance
2. Check if too much carbon in burning
room
3. Check the piston, piston ring and
cylinder for wear and damage.
↓normal
Check the trigger air gap
→abnormal Readjust the clearance
↓normal
Perform throttle control system
troubleshooting
2.8.7 Throttle control system
a . Engine speed is too high
Check AC output abnormal
Perform the generator troubleshooting
flowing the instruction of “No or Low AC
output”
↓normal
Check the stepping motor
→abnormal Replace the stepping motor
↓normal
Replace the inverter unit
b. The engine speed does not increase when smart throttle is on and load is increased.
Check the AC output
→abnormal
Perform the generator troubleshooting
flowing the instruction of “No or Low AC